SKID MOUNTED DOUBLE DRUM WIRELINE UNIT WITH OPERATOR'S CABIN
Double Drum assembly to be of all steel, non-cast,
construction with the following dimensions as requested.
15 5/8 inch wide between the flanges
20 inch diameter OD flanges
One with the Capacity of 25,000 feet .125 inch SS
One with the Capacity of 25,000 feet .108 inch SS Wireline
A large diameter
drum shaft with pillow block bearings each end will be incorporated.
Dual Brake assembly to be of dual wide brake band
construction offering good stopping, holding, and heat dissipation characteristics. A high leverage mechanical brake lever
will be installed convenient to the operator.
Drive assembly will be having chain and sprocket design with a tensioning system.
A Funk four speed transmission will be coupled to a planetary transmission which will be driven by a hydraulic motor.
Dog clutch assembly will be used for shifting between the drums.
Power drive assembly will be by a Perkins 1106-6 diesel engine.
12v start & charging system
Heavy duty cooling system w/suction fan & guards
element remote mount air filter
SAE #3 flywheel housing w/11.5"
Front and rear mounting support
Electric fuel pump
Murphy Power View panel
Engine monitoring gauges
Safety shutdown system for high engine temperature and low oil pressure
Fuel tank of 30 gallon capacity
The engine will drive the hydraulic pump
Hydraulic assembly will be of open loop design with
2000 psi working pressure. A rugged duty variable displacement pump and fixed displacement motor will be installed. Controls
will be by a directional/speed control and a remote relief valve as well as a dump valve. Safety type pressure gauges will
be installed, one to monitor the system charge pressure and one to monitor the system working pressure. Hydraulic fluid will
be supplied from a large capacity reservoir with breather/strainer filler cap and a sight level/temperature gauge. A hydraulic
oil cooler will be installed to aid the reservoir in cooling of the hydraulic fluid. A complete filtration system will be
installed. All hoses and fittings will be sized for maximum flow.
Spooling assembly will be by an underarm steering arm with a mechanical steering
system. A steering wheel will be installed at the operator's console.
A measure meter for .125 inch wireline, footage measure, will be installed onto the steering assembly. A mechanical
depth counter will be installed and will be cable driven from the register wheel. The depth counter will be installed at the
Weight indicator load cell will install
onto the measure meter and will be activated when a load is put on the wireline. Approximately 15 foot of hose will be installed
between the load cell and the dial. The dial will be installed at the operator's console. Weight Indicator must be selected
from accessories at additional cost.